NI AWR Design Environment Featured in Booth Demonstrations, Technical Presentations and an Amplifier Design Workshop at EDI CON USA 2017  

EL SEGUNDO, Calif. – NI AWR Design Environment V13 will be featured in a variety of activities at EDI CON USA 2017, being held September 11-13 in Boston. Software demonstrations in Booth #317 and conference presentations within the Low-Power RF & IoT, Radar/Defense, 5G Advanced Communications and RF and Microwave Design technical tracks as well as a power amplifier (PA) design workshop will all be showcased. Details include:

Software Demonstrations in Booth #317:

  • What’s New in NI AWR Design Environment V13
  • Microwave Office for Microwave Monolithic Integrated Circuit, RF Printed Circuit Board (PCB) and Module Design
  • Visual System Simulator™ (VSS) for Wireless Communications and Radar Systems
  • Analyst™ and AXIEM Electromagnetic (EM) Technology for Interconnect Analysis
  • AntSyn™ for Antenna Synthesis and Optimization

Technical Presentations:

  • Practical RF PCB Design
    September 12 | 9:00 a.m. | Room 110
  • Small Antenna Design for Wireless and IoT
    September 12 | 1:00 p.m. | Room 109
  • Dual-Band Compact Wi-Fi Multiple-In-Multiple-Out (MIMO) Array
    September 12 | 1:40 p.m. | Room 109
  • Transmit/Receive Front-End Module and Actively-Scanned Antenna Array
    September 13 | 9:00 a.m. | Room 108
  • Bit Error Rate, Error Vector Magnitude and Adjacent Channel Power Ratio Performance for Proposed 5G Modulation Waveforms
    September 13 | 9:40 a.m. | Room 107
  • MIMO and Beam-Steering Modeling in Support of 5G Applications
    September 13 | 10:20 a.m. | Room 107

Technical Workshop:

Advanced Load Pull for Linear PA Design Workshop
September 12 | 4:10 p.m. | Room 107

For a complete list of all NI AWR software activities at EDI CON USA 2017, visit awrcorp.com/news/events/event/edi-con-usa-2017.